Power Fist 8893539 Manuel D'utilisateur page 12

8893539
2. Place the engine (#49) onto the platform between the wheels. Position the
engine front to the right side of the body frame. Align the bolt holes in the
engine base with the platform.
a. Make sure to avoid crushing the hydraulic hose sticking out of the
platform.
3. Insert a M8*40 bolt (#34) through the platform's underside and the engine
base. Slide a Ø8 Washer (#35) and Ø8 Spring Washer (#50) onto the pin.
Secure with an M8 Lock Nut (#37).
4. Repeat step 3 with the three other bolts (#34).
5. Slide a hose clamp (#48) over the end of hose (Fig. 4-1). Insert the hose
end over the pump inlet port (Fig. 4-2). Move the clamp over the pump
inlet and tighten the clamp.
ASSEMBLY HYDRAULIC HOSES
All hydraulic hose ends screw onto the ports. Tighten the ends enough to
compress the o-rings.
1. Attach hydraulic hose A (#62) to
the control valve assembly's (D)
output port (Fig. 5-2). Connect the
other end to the body frame port
(Fig. 5-6) leading to the oil tank.
2. Attach hydraulic hose C (#63) to
the control valve assembly's input
port (Fig. 5-1). Attach the other end
to the pump output port (Fig. 5-5).
3. Attach hydraulic hose B (#61) to
the control valve assembly's
center's cylinder port (Fig. 5-3).
Attach the other end to the
cylinder port (Fig. 5-4).
12
12 Ton 3-Position Log Splitter
For technical questions call 1-800-665-8685
V4.0
Fig. 5