Care & Maintenance; Maintenance Mode - Power Fist 8893539 Manuel D'utilisateur

V4.0
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at all times.
6. Maintain the tool's labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.

MAINTENANCE MODE

Place the log splitter into maintenance mode to allow safe handling.
1. Turn off engine and allow to cool.
2. Move the control valve handle forward and backward to relieve hydraulic
pressure in the system.
3. Proceed with maintenance.
HYDRAULIC RAM MAINTENANCE
Monthly maintenance is recommended for the hydraulic ram. Any restrictions due
to dirt, rust, etc. can cause the either slow movement or extremely rapid jerks,
damaging the internal components. The following steps are designed to keep the
cylinder maintained and operational.
1. Follow lubrication instructions.
2. Visually inspect for cracked welds, bent, loose, missing parts or hydraulic
oil leaks.
3. Inspect the hydraulic ram immediately if it was subjected to an abnormal load
or shock load.
Visit www.princessauto.com for more information
12 Ton 3-Position Log Splitter 8893539
15