Wheel Assembly; Engine Assembly - Power Fist 8893539 Manuel D'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

V4.0
4.
Insert each bolt prepared in step 1 through the wedge protector, cylinder
base and beam upright bolt holes. Secure each bolt with an M10 lock nut
(#11).

WHEEL ASSEMBLY

1.
Place the tire (#39) on the wheel shaft (#48) on the side of the body frame.
2.
Slide a Ø24 x Ø8 x 2 washer (#29) onto the wheel shaft and secure with an
M8 lock nut (#37)
3.
Repeat on the other side of the body frame.
LOG GUIDE ASSEMBLY
1.
Place the left log guide (#2) onto the three bolt stems on the beam (#1).
2.
Slide a Ø20 x Ø10 x 2 washer (#10) and Ø10 spring washer (#9) onto each
bolt stem. Secure each bolt stem
with an M10 nut (#8).
3.
Repeat steps 1 and 2 with the
right log guide (#14).
4.
Push a log guard (#4) onto the
log guide receiver. Align the bolt
holes in both.
5.
Prepare 2 bolts by sliding a Ø12
x Ø6 x 1.5 washer (#6) over
each M6 x 40 bolt (#7).
6.
Insert two bolts through the log
guard bolt hole. Secure each
bolt with an M6 lock nut (#6).
7.
Repeat steps 4 to 6 on the other
side.

ENGINE ASSEMBLY

WARNING! The engine is heavy and could cause a back injury if you attempt
to move it unaided. Have a second person help to move it into position or
use a hoist capable of handling the load.
1.
Make sure the assembled log splitter is sitting on a level surface to avoid it
tipping over during assembly.
Visit www.princessauto.com for more information
12 Ton 3-Position Log Splitter
8893539
Fig. 4
11

Publicité

Table des Matières
loading

Table des Matières