Main Door Removal / Installation - Napoleon Ascent Multiface Serie Manuel D'installation Et D'opération

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10.4

main door removal / installation

WARNING
!
Glass may be hot. Do not touch glass until cooled.
If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
Remove the safety barrier, see "main safety barrier removal / installation" section.
A.
Loosen but do not remove the three securing screws from the top retainer and pull retainer away from the
B.
appliance, refer to Figure 1.
There are two latches on the top of each door, refer to Figure 2. Using the tool provided, pull the latch
C.
forward and upwards, out of the slot in the door, as shown. Ensure to keep one hand on the door at
all times, to prevent it from falling on the floor.
When both latches have been released, tilt the door forward and out of the bottom door retainer.
D.
Reverse this process to install the door.
E.
FIG. 2
FIG. 1
LATCHES
47.1
IMPORTANT: Once latches are engaged,
test that the door is secure and will not
fall forward before letting go.
W415-1285 / H / 08.07.18
finishing
EN
37

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Ascent multiface bhd4pnAscent multiface bhd4stnAscent multiface bhd4pgnAscent multiface bhd4stgnAscent multiface bhd4pfcnAscent multiface bhd4stfcn ... Afficher tout

Table des Matières