Finishing Support Adjustment - Napoleon Ascent Multiface Serie Manuel D'installation Et D'opération

finishing
EN

10.7.1 finishing support adjustment

Depending on the finishing material we have allowed from 0" (0mm) to 1" (25mm) of adjustment after the 1/2"
(13mm) combustible board has been installed. Loosen the 8 screws on each finishing support. Adjust the finishing
support to the desired position.
note:
Peninsula models have one end support that can also be adjusted by loosening the two screws.
1/2"
(13mm)
MIN
note:
Framing dimensions "A" and "B" will be affected as the finishing supports are adjusted outwards, refer to
"framing" section.
40
W415-1285 / H / 08.07.18
SIDE VIEW
B
1 1/2"
(38mm)
MAX
MIN
A
1 1/2"
(38mm)
MAX