Battery Back-Up Installation - Napoleon Ascent Multiface Serie Manuel D'installation Et D'opération

electrical information
EN
6.4

battery back-up installation

note:
In the event of a power failure, your appliance can be operated using the supplied battery back-up.
A. Remove the safety screen and door, refer to "main safety barrier removal / installation" and "main door removal
/ installation" sections.
B. Remove the panel cover using the two finger holes, then remove the control panel cover by lifting it up
and off of the four shoulder screws. This will allow you to easily access the battery housing.
C. Remove your battery housing to install the batteries, this will be located in the control compartment,
as shown below.
D. Install the four "AA" batteries, ensure the positive and negative ends correspond with those identified on the
battery housing.
E. Place the battery housing back into position or let it rest on the hearth, for the duration of the power failure.
note:
Once the power has been restored, remove the batteries from the holder.
PANEL COVER
CONTROL
PANEL COVER
30
W415-1285 / H / 08.07.18
BATTERY
HOUSING