Battery Back-Up Installation - Napoleon B42NTR Instructions D'installation Et D'utilisation

6.7

BATTERY BACK-UP INSTALLATION

ENSURE THE GAS AND ELECTRICAL POWER TO THE APPLIANCE IS TURNED OFF.
APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL THE APPLIANCE HAS COOLED.
NOTE: In the event of a power failure your appliance can be operated using the battery back-up supplied.
A. Before beginning installation, disconnect the gas and electrical power supply from the appliance.
B. Locate the battery housing supplied in the manual baggie.
C. Install four "AA" batteries (not supplied) into the battery housing, ensure the positive and negative
ends correspond with those identifi ed on the holder. (To open the battery housing, slide the back
piece upwards and off of the battery housing).
D. Remove the safety screen to easily access the control compartment.
E. Attach the wire labelled "BATTERY" from the wiring harness, located in the control compartment of
the appliance, to the battery housing.
F.
Place the battery housing into the control compartment, ensure that the battery housing is placed in a
clean and easily accessible location.
G. Reinstall the safety screen. The safety screen must be installed at all times during the appliance
operation.
H. Turn the gas and electrical power back on to begin operating the appliance.
NOTE: Once the power has been restored, remove the batteries from the holder. The system will drain
the batteries if they are left in the battery holder.
RED WIRE
!
CONTROL MODULE
BLACK WIRE
BATTERY
HOUSING
WARNING
47
EN
W415-1293 / D / 09.12.16