Battery Back-Up Installation - Napoleon Ascent 30 Serie Manuel D'installation Et D'opération

5.1

battery back-up installation

note:
In the event of a power failure, your appliance can be operated using the battery back-up supplied.
Remove the safety barrier by lifting it up and off of the four shoulder screws.
A.
Locate your battery holder, this would have been supplied in the manual baggie.
B.
Locate the red and black wires from the control module to connect to the battery holder, as shown below.
C.
Connect the red wire from the control module to the red wire of the battery back-up. Ensure the protective
D.
sleeve covers the connections, as shown below.
Connect the black wire from the control module to the black wire of the battery back-up. Ensure the
E.
protective sleeve covers the connections, as shown below.
Install 4 "AA" size batteries, ensure the positive and negative ends correspond with those identified on the
F.
holder.
Place the battery holder either onto the hearth, or in the front left corner of the control area, for the
G.
duration of the power failure, as shown below.
Ensure the safety barrier is reinstalled onto the appliance during operation.
H.
note:
Once the power has been restored, you must disconnect the battery back-up or remove the batteries
from the holder.
Red wire
Black wire
Control module
Battery housing
electrical information
W415-1768 / B / 08.10.18
EN
39