Electrical Information; Battery Back-Up Installation - Napoleon Ascent 36-1 Manuel D'installation Et D'opération

Modèles de gaz naturel et de propane
Masquer les pouces Voir aussi pour Ascent 36-1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.2

battery back-up installation

WARNING
!
Ensure the gas and electrical power to the appliance is turned off.
Appliance may be hot. Do not service until the appliance has cooled.
note:
In the event of a power failure, your appliance can be operated using the battery back-up supplied.
Remove the safety barrier by lifting it up and off of the four shoulder screws.
A.
Locate your battery holder, this would have been supplied in the manual baggie.
B.
Locate the red and black wires from the control module to connect to the battery holder, as shown below.
C.
Connect the red wire from the control module to the red wire of the battery back-up. Ensure the protective
D.
sleeve covers the connections, as shown below.
Connect the black wire from the control module to the black wire of the battery back-up. Ensure the
E.
protective sleeve covers the connections, as shown below.
Install 4 "AA" size batteries, ensure the positive and negative ends correspond with those identified on the
F.
holder.
Place the battery holder either onto the hearth, or in the front left corner of the control area, for the
G.
duration of the power failure, as shown below.
Ensure the safety barrier is reinstalled onto the appliance during operation.
H.
note:
Once the power has been restored, you should disconnect the battery back-up or remove the
batteries from the holder.
Red wire
Black wire
Control module
Battery housing

electrical information

W415-2835 / A / 12.09.20
EN
43

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

B36ntr-1B36ntre-1B36ptr-1B36ptre-1

Table des Matières