Tylo SENSE COMBI Notice D'installation page 20

Connect the electrical cable (1) to terminal (2) (see Figure
9, Page 5) according to wiring diagram (see The section
called Connection/wiring diagram, Page 8).
6
Figure 9: Circuit board
1. Electrical cable
2. Terminal for connection of electrical cable
3. Control panel cable
4. Terminal for connection of control panel
5. Sensor cable
6. Terminal for connection of sensor
7. Light cable (if relevant)
8. Terminal for connection of light (if relevant)
4. Connect the control panel cable (3) to terminal(4) (see Figure
9, Page 5) according to wiring diagram (see The section
called Connection/wiring diagram, Page 8).
5. Connect the sensor cable (5) on the terminal (6) (see The
section called Connection/wiring diagram, Page 8) ac-
cording to the wiring diagram (see The section called Con-
nection/wiring diagram, Page 8).
6. Connect light cable (if relevant) (7) see Figure 9, Page 5
to terminal (8) according to the wiring diagramFigure 19,
Page 8.
7. Close the cover and tighten the screws (see Figure 8, Page
4).
5 3 4 7
8 2 1
8. Attach the bracket and spacers to the wall following the spe-
cified dimensioning (see Figure 10, Page 5).
3
2
3
1
Figure 10: Bracket with screws and spacers
1. 760 mm
2. 280 mm
3. 185 mm
4. 230 mm (minimum distance)
9. Hang the heater on the bracket (see Figure 11, Page 5).
Figure 11: Hang the heater up.
4
5