Technical Data - Mesto 3130 Série Mode D'emploi

EN

Technical data

Type of
device quantity
3130.. 1.5 l
Welcome and congratulations
for purchasing your new pressure sprayer.
Thank you for the trust you have shown in our brand.
Intended Use
Pressure sprayers 3130.. 1.5 l are suitable for spraying water-based
liquid foods, water, saline solutions, acetic acid solutions, low-concen-
tration alcoholic solutions, viscous oils, and oily solutions permitted for
food contact.
Not suitable for, and not to be used under any circumstances for:
• Wetting agents (surfactants), solvents, and liquids containing solvents
which can cause or promote cracking in the applied plastics.
• highly viscous or sticky liquids or liquids that leave residue which can-
not be completely rinsed out of the device.
safety instructions of the agent manufacturer. Products other than those
above are not in conformity with proper use.
The manufacturer shall not be liable for any resulting damages or for
Your Safety
Do not leave the device in the sun.
Check each time before using:
• Are all parts that are under pressure and convey liquids free of
damage?
• Are those parts functioning properly?
Replace devices that are damaged or not functioning properly
immediately.
Follow the spray manufacturer's instructions.
2293920 Original operating instructions
Total Max.
contents pressure
2.0 l 3 bar
Max. Weight
temperature when empty
30 °C 465 g
Never direct spray at persons, animals, or bodies of water.
Do not blow through clogged nozzles or valves with your mouth.
Making the Device Ready for Use
• Slowly open the pump counterclockwise a 1/4 turn and wait until the
tank is no longer pressurized.
• Unscrew the pump from the tank.
•
• Screw the pump tightly onto the tank.
• Generate pressure in the tank by activating the pump
Use
• To spray, activate the lever on the pump.
• Releasing the lever interrupts the spray process immediately.
• The spray pattern can be optimally adjusted by turning the nozzle.
After Usage
• Slowly open the pump counterclockwise a 1/4 turn and wait until the
tank is no longer pressurized.
• Unscrew the pump from the tank.
• Never leave liquid in the device.
Empty and rinse the device with clear water.
• Do not dispose of residue as wastewater through the drain!
Dispose of surplus environmentally harmful products as hazardous
waste.
MESTO Spritzenfabrik Ernst Stockburger GmbH
Ludwigsburger Straße 71, D-71691 Freiberg/Neckar, www.mesto.de 0719
Material of Max. pumping
tank volume
Polyethylene 1.15 l/min/3 bar