Setting The Shaking Speed; Stopping And Starting The Shaking - VWR 462-0493 Manuel D'instructions

3.6.3 Setting the shaking speed

To set the shaking speed:
The shaking speed can be checked at anytime by pressing the rpm button. The speed is
displayed for 2 seconds.
The maximum speed for a particular application will depend on number and size of vessels,
and the depth of the water. The shaking trolley is driven by a drive magnet under the tank,
magnetically coupled to the trolley through the tank. As the speed is increased, a point is
reached where the magnetic coupling de-latches, causing the trolley either to move erratically
or to stop. Reduce the speed to restore the magnetic coupling.
Take care when operating after a power interruption. Shaking will start at the previously set
speed.

3.6.4 Stopping and starting the shaking

The shaking will start at the speed previously set using the rpm button. If no speed has
been set then the display will show when start is pressed.
VWR shaking water bath Instruction Manual
European edition
Press the rpm button

Select speed between 20

and 200. The trolley will
move at the displayed
speed
After 5 seconds the
.
display will revert to
showing the water
temperature and the tray
will continue to shake
To stop the shaking,

press button once
To start the shaking

press button once
EN
32136 V3
Page 7