Recharging The Powerpette Pro; Fitting The Powerpette Pro Wall Bracket - VWR Powerpette Pro Mode D'emploi

Recharging the Powerpette Pro

Before starting to operate, carefully check mains voltage and recharge batteries. To charge the
Powerpette Pro:
Plug the charger jack (6) into the base of the Powerpette Pro.
•
Plug the charger (5) into a suitable wall socket. The red indicator on the charger will light up.
•
Place the Powerpette Pro onto bench stand.
•
Allow the unit to charge for 16 hours from empty to fully charged.
•
Once the Powerpette Pro is fully charged, the charger automatically switches to a trickle charge
•
operation and the indicator light turns green. If the charge to the Powerpette Pro is interrupted
and then re-started the charger will begin its 16 hour cycle and will switch to a trickle charge
operation as above. This will not damage the battery.
Only use the charger indoors and protect against moisture.
•
Recharging temperature +10 °C to +35 °C.
•

Fitting the Powerpette Pro wall bracket

The Powerpette Pro bench stand is supplied ready to use as a wall bracket. When used as
a bench stand it is recommended that the wall fitting is removed.
Bench stand Wall bracket
Wall fitting
|
EN INSTRUCTION MANUAL
5
|
VWR