Figure 7; Connecting The Training Electrode Packet To The Lifepak Cr-T Aed Trainer; Conducting A Training Session - Medtronic LIFEPAK CR–T AED Mode D'emploi

2 Slide and release the
MASTER POWER
3 Check to confirm that the existing setup configuration is appropriate for the training scenario. If not,
change the setup configuration as desired (refer to
information).
4 If preparing for a training session on the automatic model of the defibrillator, place the yellow plastic
cover, stored in the storage compartment (refer to pages 3 and 4), over the
Two Quick Start Reference Cards are provided in
include a condensed description of the steps to complete when preparing the Trainer for a training
scenario. The cards are perforated for easy removal and may be photocopied.
Connecting the Training Electrode Packet to the LIFEPAK CR–T AED TRAINER

Figure 7

CONDUCTING A TRAINING SESSION

1 Verify that power to the Trainer is on and the OK indicator appears in the readiness display.
2 Proceed with the training session.
LIFEPAK CR–T Trainer Operating Instructions
©2002-2006 Medtronic Emergency Response Systems, Inc.
USING THE LIFEPAK CR–T AED TRAINER
switch to provide power to the Trainer.
Section 3, beginning on page 15 for setup
Appendix B, beginning on
button.
SHOCK
page 33. These cards
13