Preparing For A Training Session - Medtronic LIFEPAK CR–T AED Mode D'emploi

USING THE LIFEPAK CR–T AED TRAINER
Remote Control Button Functions (Continued)
Table 6
Button Function
OP L Adjust volume of voice
prompts
GREEN SELECT
RED SELECT
button
UP ARROW
RIGHT ARROW
Using the Remote Control Cable
To use the remote control cable, insert the cable's right-angle connector into the remote control
receptacle. Insert the connector on the opposite end of the cable into the receptacle located on the side
of the Trainer (see Figure
Disconnect the remote control cable by grasping the connector on the side of the Trainer and gently pulling
away from the Trainer. Disconnect the right-angle connector from the remote control in the same way.

PREPARING FOR A TRAINING SESSION

1 Connect the electrode packet to the Trainer as follows:
– Press the
LID RELEASE/ON-OFF
– Insert the electrode pads connector into the Trainer cable receptacle until it snaps into place
(see Figure 7).
– Insert the black plastic anchor pin on the electrode packet into the anchor receptacle at the upper
left corner of the Trainer (see
– Ensure that the lower edge of the packet is under the fin on the lower front part of the Trainer.
– After the electrode packet is in place, close the Trainer lid.
12
Operation and Description
Each time the Trainer is turned on, the volume level defaults to
the level used during the previous session.
Three volume levels are available (low, medium, high). Press the
VOLUME CONTROL
you press the button, the volume increases. View the LED
display to observe volume changes. When the highest volume is
reached, the next press returns the volume to low.
The
GREEN SELECT
button
and general operating setting options.
When the
flashes green to indicate setup mode is activated.
Press the
protocol.
For more information, refer to
The
RED SELECT
button
CPR Time 2, and the Language Option.
When the
red to indicate setup mode is activated.
For more information, refer to
The
UP ARROW
The
RIGHT ARROW
button
settings.
2, page 4).
button to open the Trainer lid.
Figure 7).
button to select the volume level desired. As
button is used to change the shock protocol
button is pressed, the LED display
GREEN SELECT
button twice to display the shock
GREEN SELECT
Section
button is used to change CPR Time 1,
button is pressed, the LED display flashes
RED SELECT
Section
button is used to select a setting option.
button is used to advance through the
LIFEPAK CR–T Trainer Operating Instructions
3, beginning on page 15.
3, beginning on page 15.