GETTING STARTED
INSTALLING AND REPLACING BATTERIES
The following paragraphs provide the procedures for installing or replacing LIFEPAK CR–T AED
TRAINER and remote control batteries.
Installing and Replacing Trainer Batteries
Four D-cell alkaline batteries provide power to the Trainer. The batteries are installed in a compartment
in the bottom of the Trainer. Fresh batteries provide approximately 100 hours of continuous Trainer
operation.
To install the batteries:
1 Verify that power to the Trainer has been turned off (using the
2 Carefully turn the Trainer upside down.
3 Remove the battery compartment cover by depressing both latches on the cover and lifting the
cover.
4 Insert four fresh, identical batteries, taking care to align the (+) and (-) terminals correctly. The
correct battery placement is shown in
5 Replace the cover and press down until you hear the latches snap into place.
Note: Always replace all of the batteries at the same time. Always use four identical batteries.
Note: For permanent storage (longer than six months), remove the batteries from the battery
compartment. If the Trainer is used infrequently (approximately once every six months), the
batteries can remain in the battery compartment.
Installing and Replacing Remote Control Batteries
Two AAA alkaline batteries provide power to the remote control. The batteries are located in a
compartment on the bottom of the remote control. (See
To replace the remote control batteries:
1 Turn the remote control upside down.
2 Open the battery compartment by sliding the battery compartment cover down with firm thumb
pressure.
3 Insert two fresh, identical batteries, taking care to align the (+) and (-) terminals correctly.
4 Replace the battery compartment cover, sliding it up until it snaps securely into place.
LIFEPAK CR–T AED TRAINER and Remote Control Battery Placement
Figure 6
8
Figure
6.
Figure
+
–
+
D-Cell
D-Cell
-
–
+
–
D-Cell
D-Cell
switch).
MASTER POWER
6.)
–
+
LIFEPAK CR–T Trainer Operating Instructions