O.rear Wheel Spacing; Seat Sling Adjustment; Q.rear Seat Height Adjustment - Quickie 5R Manuel D'instructions

Q UI C KIE 5R
O. REAR WHEEL SPACING
Rear wheel spacing is measured as the gap between the top of the rear wheels and the backcanes, and
is shown as dimension (A) factory settings will be as narrow as possible depending on the options cho-
sen.
NOTE –When setting the rear wheel spacing only make adjustments to one side of the chair at a time.
Loosening both sides will undo the toe setting.
a.
To adjust the rear wheel spacing, the camber inserts (B) telescope in and out of the camber tube
(C) with hard stops at each end of travel.
b.
On the left side of the chair, loosen screw (D) (the one closest to the camber tube). Slide the
camber insert in or out to establish the required wheel spacing.
c.
Tighten screw to 100 in-lbs (11.3Nm). Repeat on the right side of the chair, matching the wheel
spacing set on the left side.
P.

SEAT SLING ADJUSTMENT

a.
Remove the bolts (E) and rear bolt nut (F) to allow seat upholstery (G) to be removed from
frame.
b.
To reattach seat sling, place seat sling (G) over chair frame. Line up seat sling and plastic saddles.
Replace the screws (E) and rear nut (F) and tighten accordingly.
c.
Retain plastic saddles (not shown) for placement between seat sling and frame. Repeat steps for
other side.
If there is any difficulty in reattaching the screws, try using a probe to help align the holes. Ensure that
the plastic saddles are under the seat rail in all fastener positions.
Q. REAR SEAT HEIGHT ADJUSTMENT
a.
To adjust rear seat height, loosen and remove the 4 cap screws ( H) (2 per side) that secure the
camber tube clamps ( I ) to the axle plates ( J ).
b.
Move both camber tube clamps (I) to the desired height and reinstall the 4 cap screws. Prior to
tightening, follow the instructions for setting the toe-in/out to zero.
c.
Tighten screws to 100 in-lbs. (11.3 Nm).
NOTE – Adjustment to rear seat height may also require caster angle adjustment.
52 53 54
55
56
27
52
53
54
D
56
I
H
J
MK-100083 Rev. A