Rear Wheel Spacing; Back Angle Adjustment - Quickie 7R Mode D'emploi

Q UI C KIE 7R
R. REAR WHEEL SPACING
Rear wheel spacing is measured as the gap between the top of the rear wheels and the backcanes, and is shown
as dimension (X ) Factory settings will be as narrow as possible depending on the options chosen.
NOTE– When setting the rear wheel spacing only make adjustments to one side of the chair at a
time. Loosening both sides will undo the toe setting.
T
o adjust the rear wheel spacing, the camber inserts (A) telescope in and out of the camber tube (B) with hard
stops at the outer limit of travel. On the left side of the chair, loosen screws (C) (the ones closest to the cam-
ber tube). Slide the camber insert in or out to establish the required wheel spacing. Tighten screw to 62 in-lbs.
(7 Nm). Repeat on the right side of the chair, matching the wheel spacing set on the left side.
S. BACK ANGLE ADJUSTMENT
Adjusting Backrest Options
Backrest bracket has two positions, Forward Mount and Rearwad Mount. Change the bracket posi-
tion by removing bolt (D) and pivoting the bracket forward or rearward. Reinsert the bolt in the new
position and tighten. Then follow the instructions for "Folding and Unfolding backrest".
F= Forward Mount R= Rearward Mount
Backrest Angle Preset Plugs
The preset plugs allow you to unemploy the backrest bracket holes you do not wish to use. This
allows the backrest to automatically lock into your desired angle position after unfolding.
1. Determine which backrest bracket holes you do not want to use.
2. Insert plugs (E) into the predetermined holes from the chair side of the bracket (G).
3. To ensure the backrest will lock in the folded position, do not insert a plug into the lowest
hole position (F).
Test the new chair settings with a spotter before proceeding with use.
69 70
71 72 73
72
73
WARNING
IX. DEALER SERVICE AND ADJUSTMENT
29
EQUAL
X
Forward
D
Rearward
D
E
G
F
MK-100084 Rev. A
69
70
71
72
73