Back Angle Performance; L.backrest Tension Adjustable - Quickie 5R Manuel D'instructions

Q UI C KIE 5R
K. BACK ANGLE PERFORMANCE
Adjusting the Angle of the Backrest
1. Release the backrest by pulling the adjustable tension pull cord (A) with a simple, short force.
2. While maintaining tension on the release cord, rotate the backrest to the desired angle, either forward
or rearward.
3. Lock the backrest in place by releasing the cord and allowing the pins (B) to engage in the nearest hole
(C) of the backrest bracket (D).
Folding and Unfolding the Backrest
1. Release the backrest by pulling the adjustable tension pull cord (A) with a simple, short force.
2. While maintaining tension on the release cord, rotate the backrest to unfold it. Remove the cushion
and push down hard to lock it in the folded position.
3. Lock the backrest in the folded position by removing your cushion. Release the pull-cord, and push
down hard allowing the pins (B) to engage in the folded position hole (E) of the backrest bracket (D).
Be sure the pins (B) are fully engaged through the backrest bracket (D) on both sides of the chair,.
Test the backrest to be sure it is locked before use.
L. BACKREST TENSION ADJUSTABLE
To install the Backrest Tension Adjustable
®
1. Slide Velcro straps (F) over the backrest frame (G) section. Make sure to include at least
one strap below the towel bar (if using a rigid chair).
2. Tighten the straps appropriately to desired tension level. DO NOT over tighten straps as
this will cause undue strain upon the chair backrest frame (G).
3. If using fold down push handles, insert the single Velcro
front of the push handles ( I ).
If using integral push handles ( J ), slide straps from bottom of backrest upward.
4. Install backrest cover at desired level and fold over rear of Velcro
The Quickie patch should be upright on the rear of the chair.
5. Finish installation by placing vanity flap (center panel) down onto Velcro
to secure attachment (L).
Adjusting the Backrest Tension Adjustable
Always use anti-tips while making any adjustments. Ensure anti-tips are safely secured and in a
position to prevent the wheelchair from tipping backwards.
1. User can transfer into wheelchair. Place wheel locks in the locked position
2. From the rear of the wheelchair the attendant can lift the Vanity Flap (center panel) to
access the strap system. Adjust straps for optimal balance and trunk alignment. Ensure the
®
Velcro straps has a minimum of 2 inches (5cm) of engagement. Hook the Velcro
securing it through each loop. Press the Velcro
3. Once adjustments are complete replace Vanity Flap to its original position.
Any changes made to the straps will affect the center of gravity. It is best to have the attendant
stationed behind the wheelchair to prevent the wheelchair from tipping backwards while the user
becomes accustomed to the adjustment.
MK-100083 Rev. A
17 18
WARNING
19 20 21 22
®
strap (F) through the slots in the
®
®
together to ensure its securely engaged.
WARNING
18
strapping system (K).
®
on the seat sling
®
after
17
18
E
19
F
G
20
H
I
21
J
F
22