G.armrest Receiver Attachment; H.padded Swing-Away Armrests Option; Footrest Adjustment - Quickie 5R Manuel D'instructions

Q UI C KIE 5R
G. ARMREST RECEIVER ATTACHMENT
1. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost (A) in the receiver (B):
a. Loosen the four receiver adjustment bolts (C) on the sides of the receiver.
b. With the armrest in the receiver (B), squeeze the receiver to achieve the desired fit.
c. Tighten the four bolts (C). (144 in-lbs, 16.3 Nm)
2. Position Adjustment
a. Loosen the three clamp bolts (E) until clamp (D) is loose.
b. Slide armrest receiver to desired position.
c. Tighten all three bolts (E) to 212 in-lbs. (24 Nm).
H. PADDED SWING-AWAY ARMRESTS (OPTION)
Swing-away armrests can be detached or can swing away (F) to allow lateral transfers. They are
height adjustable 6" (15cm) of adjustment in 1" (2.5cm) increments by moving bolts (H) up or down
in predrilled holes on armrest receiver (G).
Swing-away, angle adjustable
To change the angle of the armrest, remove the hardware (H). Reposition to the desired angle.
Reinsert the hardware and tighten.
I. FOOTREST ADJUSTMENT
The footrest is an integral part of the frame. Do not remove the footrest. It is recommended that
you maintain a minimum of 2 inches (5cm) between the lowest point on the footrest and the floor
(I). This will provide adequate clearance for uneven surfaces and prevent damage to your footrest.
1. Height and angle adjustment
a. Adjust the height of your footrest, by loosening the Set screws ( I ) in the front hanger frame.
b. To adjust the angle of the footplate, loosen the screw ( J ) and rotate the footrest angle stop
bracket. Once positioned, retighten screw(s) (J) to 92 in-lbs. For certain narrow widths, only
one bolt will be present.
c. Remember to tighten the set screws ( I ) before riding, use a maximum torque setting of 144
in-lbs or (16.3 Nm)
2. Tubular Footrest height adjustment
a. Loosen the two clamp set screws in the back of the hanger frame tubes (K) on both sides of
the chair.
b. Slide footrest to desired height.
c. Tighten the hardware to 144 in-lbs (6.3 Nm) on both sides.
MK-100083 Rev. A
29 30
30
32 33
WARNING
33
31
22
29
30
E
31
F
G
H
32
I
J
33
K