Marked Cutting; Plunge Cuts; Change Saw Blade - Batavia T-Raxx BT-PS002 Mode D'emploi

MARKED CUTTING

1. Turn the selector switch (18) to marked cut
function.
2. Press the switch lock (1) and push the
motor down. The casing stops in 2.5 mm
cutting depth position.
Note: The marking line should be aligned
with cutting line A

PLUNGE CUTS

1. For a straight cut first loosen both rotary
knobs (8) and swivel the plunge saw to 0°
position on the scale. Tighten the rotary
knobs again.
2. Turn the selector switch (18 to plunge cut
function.
3. Set the desired plunge depth. Ensure that
the guide rail track compensation (10) is up
if not using the guide rail.
7061494-T-Raxx_1200W-Ma-1805-17.indd 27
(0 mark).
4. Press the switch lock (1) and the ON/OFF
switch (2) and push the motor down. Guide
the saw forward to cut.
Note: To prevent the saw from kicking back
during plunge cuts follow these steps:
• Always place the plunge saw with the rear
edge of the base plate (4) against a fixed
limit stop.
• Hold the plunge saw in both hands and
slowly lower the saw blade.
• The cutting width marks (16) show the most
foremost and rearmost cutting points of the
saw blade (Ø 165 mm) at maximum cutting
depth and when using the guide rail.

CHANGE SAW BLADE

Before any maintenance work always switch
off the plunge saw and disconnect from mains
power.
1. Loosen both rotary knobs (8) and swivel the
plunge saw to 0° position before changing
the saw blade. Tighten the rotary knobs
again.
2. Set the selector switch (18) to the change
saw blade icon.
3. Press the switch lock (1) down and push
the motor down.
4. Press and hold the spindle arrester down.
5. Use a 5 mm Allen key to turn the screw at
the saw blade slightly clockwise or counter-
clockwise until the spindle clicks into place.
EN
27
17-05-18 10:30