Grizzly EKS 2240 QTX Traduction De La Notice D'utilisation Originale page 170

GB
contacting anything. A moment of
inattention white operating chain saws
may cause entanglement of your cloth-
ing or body with the saw chain.
Always hold the chain saw with
b)
your right hand on the rear handle
and your left hand on the front
handle. Holding the chain saw with a
reversed hand configuration increases
the risk of personal injury and should
never be done.
c) Wear safety glasses and hear-
ing protection. Further protective
equipment for head, hands, legs
and feet is recommended. Adequate
protective clothing will reduce person-
al injury by flying debris or accidentaI
contact with the saw
d) Do not operate a chain saw in a
tree. Operation of a chain saw white
up in a tree may result in personal in
jury.
e) Always keep proper footing and
operate the chain saw only when
standing on fixed, secure and level
surface. Slippery or unstable surfaces
such as ladders may cause a loss of
balance or control of the chain saw.
f) When cutting a Iimb that is under
tension be alert for spring back.
When the tension in the wood fibres is
released the spring loaded Iimb may
strike the operator and/or throw the
chain saw out of control.
g) Use extreme caution when cutting
brush and saplings. The slender
material may catch the saw chain and
be whipped toward you or pull you off
balance.
Carry the chain saw by the front
h)
handle with the chain saw switched
off and away from your body. When
transporting or storing the chain
saw always fit the guide bar cover.
170
chain.
Proper handling of the chain saw will
reduce the Iikelihood of accidentaI
contact with the moving saw chain.
Follow instructions for lubricating,
i)
chain tensioning and changing ac-
cessories.
Improperly tensioned or lubricated
chain may either break or increase the
chance for kickback.
k) Keep handles dry, clean, and free
from oil and grease. Greasy, oily
handles are slippery causing loss of
control..
Cut wood only. Do not use chain
l)
saw for purposes not intended. For
example: do not use chain saw for
cutting plastic, masonry or non-
wood building materials. Use of the
chain saw for operations different than
intended could result in a hazardous
situation.
m) Hold the power tool only on the in-
sulated handle surfaces, as the saw
chain can come into contact with
concealed power lines or the mains
cable to the equipment. Contact
between the saw chain and a live wire
can make metal parts of the equip-
ment live and cause an electric shock.
7) CAUSES AND OPERATOR PRE-
VENTION OF KICKBACK
Beware of kickback! Be careful of
kickback of the machine during
work. There is danger of injury
here. You can avoid kickbacks by
exercising caution and using a cor-
rect sawing technique.
Kickback may occur when the nose or
tip of the guide bar touches an object, or
when the wood closes in and pinches the
saw chain in the cut.