Samoa 560 230 Manuel D'utilisation page 34

836 828 R. 01/16
8
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
Calibration
Calibration mode
Display of current calibration factor and
restoring factory factor
By pressing the CAL key while the appliance is in
been restored after previous calibrations, the
following display page will appear:
The word "Fact" abbreviation for "factory" shows
that the factory calibration factor is being used.
If, on the other hand, calibrations have been
made by the user, the display page will appear
showing the currently used calibration factor (in
our example 0,998).
The word "user" indicates a calibration factor
set by the user is being used...
The flow chart alongside shows the switchover
logic from one display page to another. In this
condition, the Reset key permits switching from
After the restart cycle, the meter uses the
calibration factor that has just been confirmed.
W
HEN THE
U
SER FACTOR IS DELETED FROM THE MEMORY
Standby, the display page appears
showing the current calibration factor
used. If no calibration has ever been
performed, or the factory setting has
User factor to Factory factor.
To confirm the choice of calibration
factor, quickly press CAL while "User"
or "Fact" are displayed.
ATTENTION
F F
ACTORY ACTOR IS CONFIRMED
,
THE OLD
.