Servicing Air Cleaner; Changing Fuel Filter; Changing Oil - Miller Blue Star 185 Manuel Du Propriétaire

8-3. Servicing Air Cleaner

1

8-4. Changing Fuel Filter

Tools Needed:

8-5. Changing Oil

2
1
Tools Needed:
OM-267 212 Page 30
2
1
.
Complete Parts List available at www.MillerWelds.com
! Stop engine. Let cool
NOTICE − Do not run engine with-
out air cleaner element or with dirty
element.
1 Screw
2 Foam Element
Inspect foam element. If element is
damaged, replace. If element is
clogged, wash foam element with
soap and water solution. Allow to air
dry completely.
.
Do not wring out foam element,
this could cause it to tear.
Oil foam element using clean en-
gine oil. Squeeze out excess oil.
The engine will smoke if excess oil
remains.
! Stop engine. Close fuel
valve. Let cool.
! After servicing, start engine
and check for fuel leaks.
Stop engine, close fuel valve,
tighten connections as ne-
cessary, and wipe up spilled
fuel.
1 Fuel Filter
Locate fuel filter below fuel tank.
Release hose clamps and remove
filter. Replace filter . Ensure flow ar-
row points towards carburetor.
.
Change oil while engine is
warm. Make sure engine is
level when filling, checking,
and changing the oil.
1 Oil Drain Plug
2 Oil Fill/Check Plug
Remove the oil drain plug and oil fill/
check plug. Be sure to allow ample
time for oil to drain completely.
2
Reinstall drain plug and tighten to
13 ft lb (17.6 N⋅m).
Fill crankcase with proper amount
and viscosity of oil according to
1
maintenance label in Section 8-2.
Reinstall oil fill/check plug.
Kohler 17 690 01 Rev E
804 081-B
Kohler 17 690 01 Rev E