Engine Prestart Checks - Miller Blue Star 185 Manuel Du Propriétaire

5-5. Engine Prestart Checks

1
OM-267 212 Page 22
.
Complete Parts List available at www.MillerWelds.com
1/2 in
(13 mm)
Full
Low
Check all fluids daily. Engine must
be cold and on a level surface. Unit
is shipped with 10W30 engine oil.
1 Fuel Valve
Open valve.
.
Close fuel valve before moving
unit or carburetor may flood
and make starting difficult.
Fuel
Add fresh fuel before starting
engine the first time (see engine
manual for specifications). Fill fuel
tank up to 1/2 in. (13 mm) from top
to allow room for expansion. Check
fuel level on a cold engine before
use each day.
Oil
After fueling, check oil with unit on
level surface. If oil is not up to full
mark on dipstick, add oil (see en-
gine manual).
Unit stops if oil level is too low. Unit
cannot be restarted until sufficient
oil is added.
.
To improve cold weather
starting:
Keep battery in good condition.
Store battery in warm area off
concrete surface.
Use correct grade oil for cold
weather, see Section 8-2.
Maintenance Label.
Filler Neck
Bring Level Up To
Point Of Overflow
268 699 / 267 206