Mounting; Tips And Advice On Installation - SOMFY Eolis io Notice

EN

2.4. MOUNTING

1) Drill two holes, 38 mm apart and horizontally aligned.
2) Push the plugs (D) in (use the plugs supplied or a suitable
model for the medium).
3) Fix the sensor mounting bracket (G) to the wall using the
screws (C) supplied.
4) Insert the protective housing (F) into the mounting bracket (G)
until it clicks into position.
5) Fix the protective housing (F) onto the mounting bracket
using the screws.
6) Connect the cable (B) to the power supply.

2.5. TIPS AND ADVICE ON INSTALLATION

2.5.1. Questions about the Eolis io?
Observations
The io motor or receiver memory
is full.
The sensor cannot
The sensor is mounted to a
be paired with the io
metal part.
motor or receiver.
The sensor is not within the io
motor or receiver's range.
The sensor is not operating.
The motorised
product rises once
an hour.
The sensor is not within the io
motor or receiver's range.
The sensor does not work be-
cause the wiring is incorrect.
The motorised
The sensor is not paired with the
product does not
io motor or receiver.
automatically retract
The threshold is incorrectly set.
when the wind is
detected.
External radio equipment is in-
terfering with the radio reception
(e.g. Hi-Fi radio headphones).
20
Possible causes
Copyright © 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1)
2)
D
5)
6)
F
7)
F
Solutions
Unpair at least one sensor to be able to
connect the Eolis io sensor.
Move the sensor to distance it from the
metal part.
Move the sensor closer to the io motor
or receiver.
Check the operation of the motorised
product with the io control point.
Check the operation of the sensor on the
motor using the Demo mode.
Replace the sensor if it is faulty; see
2.5.4.
Move the sensor closer to the io motor
or receiver
Check the sensor wiring; see 2.2.
Pair the sensor with io motor or receiv-
er; see 2.4.
Alter the threshold; see 2.4.4.
Turn off all radio equipment nearby.
Eolis io
C
G
G