Wind And Rain Functions In Comfort Mode; Questions About The Eolis Io - SOMFY Eolis io Notice

Eolis io

3.3. WIND AND RAIN FUNCTIONS IN COMFORT MODE

Applicable if an Ondeis rain sensor is connected to the Eolis io sensor and comfort mode is selected.
3.3.1. The wind begins to blow (and it is or is not raining)
When the wind exceeds the set sensitivity threshold:
• The wind LED is permanently lit green,
• The motorised products connected to the Eolis io sensor move to the safety position
automatically.
͉
͉
It is impossible to prevent the motorised products from reacting or to change their position while the
wind is blowing stronger than the threshold set.
3.3.2. The wind stops blowing and it is not raining
When the Eolis io sensor no longer detects any wind for 30 s and the Ondeis rain sensor does not
detect any rain:
• The Wind LED goes off.
• It is then possible to control the motorised products in manual mode.
• All the automatic functions will remain locked for another 11 min 30 s.
3.3.3. The wind stops blowing and it is raining
When the Eolis io sensor no longer detects any wind for 30 s and the Ondeis rain sensor detects rain:
• If it is paired with a Somfy io bi-directional control point, such as TaHoma or Connexoon, via the
Eolis io, the programmed scenario is activated.
• The automatic functions will remain locked for another 11 min 30 s. If the Ondeis sensor
detects rain after this time frame via the Eolis io, the motorised products automatically move
to the bottom end limit.
3.4. QUESTIONS ABOUT THE EOLIS IO?
Observations
The motorised product does
not automatically retract
when the wind is detected
The motorised product rises
once an hour.
Copyright © 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
Possible causes
External radio equipment
is interfering with the radio
reception (e.g. Hi-Fi
headphones).
The threshold is incorrectly set.
The sensor is not operating.
Solutions
Turn off all radio equipment
nearby.
radio
Alter the threshold; see 2.4.4.
Contact an installer.
EN
23