Initial Setting - SOMFY Eolis io Notice

Eolis io
2) Turn the wind potentiometer (J) to the Demo position.
The motorised product moves up and down briefly.
3) Turn the anemometer (E) manually to simulate the wind
blowing.
The motorised product automatically moves to safety position
after 2 seconds.
The Eolis io sensor is paired with this io motor or receiver.
Attention
Never leave the wind potentiometer set to "Demo".
2.3.3. Setting the wind sensitivity threshold
Table of thresholds
͉
͉
In addition to the value in km/h and the number of flashes indicating the level set, the corresponding
value on the Beaufort scale is given for information purposes.
Thresholds
km/h
Number of flashes
Beaufort equivalent

Initial setting

Set the wind potentiometer (J) to the threshold adapted to the type of motorised product according
to the table of thresholds.
After about 2 seconds, the wind LED flashes a certain number of times indicating the threshold
level set.
Adjusting the threshold
The sensitivity threshold setting can be changed according to the actual weather conditions and
requirements.
1) Turn the potentiometer to the right or left until the wind LED
(I) is permanently lit green:
The wind sensor's sensitivity threshold is set according to the
current wind value.
͉
͉
Note:
- Wind LED off: the sensitivity threshold set has not been reached, the wind is blowing below the
set threshold: the motorised product does not move.
- Wind LED permanently lit green: the sensitivity threshold set has been reached, the wind is
blowing above the set threshold: the motorised product moves to the safety position.
2) Check that the motorised product reacts automatically when
the wind blows stronger than the threshold set and that, in
these conditions, the motorised product is not damaged.
If the motorised product does not react as desired, adjust the
sensitivity threshold:
• Turn the potentiometer towards the (+) sign to increase the sensitivity threshold: a stronger
wind causes the motorised product to be moved to the safety position.
• Turn the potentiometer towards the (-) sign to decrease the sensitivity threshold: a weaker
wind causes the motorised product to be moved to the safety position.
Copyright © 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1 2 3
28 38 49
★ ★ ★ ★ ★ ★
Bf 5 Bf 6 Bf 7
2)
3)
4 5
61 74
★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
Bf 8 Bf 9
1)
2)
EN
6
88
Bf 10
19