SOMFY Eolis io Notice page 19

Eolis io
To add the wiring for the Ondeis rain sensor after the Eolis io sensor has been installed, follow the
procedure below:
1) Switch off the mains power supply.
2) Remove the protective housing (F).
3) Unscrew the front panel (K) of the mounting bracket to access
the terminal block.
Attention
Never remove the cover located under the anemometer.
4) Unscrew the right-hand metal tab (O).
5) Drill a hole in the right-hand sealant pad (P).
Attention
• Never remove the sealant pad.
• The hole drilled in the pad must not exceed the diameter
of the cable in order to maintain tightness.
6) Feed the Ondeis output cable (Q) through the right-hand
sealant pad.
7) Connect the Ondeis sensor output cable (R) to the Eolis io
sensor using the right-hand terminal block marked "RAIN" (S).
8) Screw in the metal tab (T): the cable must be fed under the tab.
Attention
The cable sheath must exceed the tab by at least 2 mm.
2.2.3. Activating the Ondeis rain sensor
Presentation of the operating modes
When it is connected to the Eolis io sensor, the Ondeis rain sensor can be configured in 2 operating
modes: safety mode or comfort mode.
• In safety mode, the motorised product moves to the safety position if the Ondeis sensor
detects rain. This position is determined by the type of motorised product and protects the
motorised product from the rain.
• In comfort mode, when the Ondeis sensor detects rain:
- if it is paired with a Somfy io bi-directional control point, such as TaHoma or Connexoon, via
the Eolis io, follow the instructions for this control point.
- Otherwise, position the motorised product at the lower end limit. This mode serves, for
example, to protect users from the rain under their awning.
Copyright © 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1)
2)
F
3)
K
4)
5)
6)
7)
230V
8)
≥2mm
T
EN
OFF
90°
STOP
O
P
Q
S
R
RAIN
≥2mm
17