Soliris Io In Detail; Installation; Installation Recommendations; Mounting The Sensor Bracket - SOMFY Soliris io Notice

Soliris io
1.6. SOLIRIS IO IN DETAIL
Description
E Sun sensor
F Anemometer
G Protective housing
H Mounting bracket
I PROG button
J Sun LED
K Wind LED
L Sun potentiometer
M Wind potentiometer

2. INSTALLATION

2.1. INSTALLATION RECOMMENDATIONS

• Choose a location with maximum wind detection and which is not hindered by obstacles: install the
sensor in a location that is not sheltered from the wind
• Choose a sunny location where sunshine detection is compatible with wind detection.
• Install the sensor near the product which it controls.
• Never install the sensor underneath the motorised product or
under artificial lighting.
• Always fit the sensor with the anemometer (F) on top!
͉
͉
The articulated structure of the Soliris io sensor enables it to be
mounted on walls or roofs with a slope of up to 15°.

2.2. MOUNTING THE SENSOR BRACKET

1] Drill two holes, 38 mm apart and horizontally aligned.
2] Push the plugs (D) in (use the plugs supplied or a suitable model
for the medium)
3] Remove the protective housing (G) and then fix the sensor
mounting bracket (H) to the wall using the screws (C) supplied.

2.3. WIRING

2.3.1. Soliris io wiring
Attention
Perform disassembly and wiring operations away from any dust, moisture or foreign bodies to maintain
tightness.
Copyright © 2019-2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
E
G
H
L
M
1]
2]
D
3]
EN
F
I
J
K
C
H
17