Emerson Micro Motion D Série Notice D'installation page 19

9-wire cable wiring
Follow the steps below to connect the 9-wire cable between the sensor
and the transmitter.
1. Prepare the cable according to the instructions in Micro Motion's
9-Wire Flowmeter Cable Preparation and Installation Guide.
2. Insert the stripped ends of the individual wires into the terminal
blocks. No bare wires should remain exposed.
• For D and DL sensors, match the wires color for color. For wiring
at the transmitter, refer to the transmitter Quick Reference Guide.
• For DT sensors, connect the sensor cable wires to the junction
box terminals. Then, connect the 9-wire cable to the junction box
terminals, matching the colors of the wires to the numbers of the
DT sensor terminals, as indicated in Table 4. For wiring at the
transmitter, refer to the transmitter Quick Reference Guide.
3. Tighten the screws to hold the wires in place.
4. Ensure integrity of gaskets, then tightly close and seal the
junction box cover and all housing covers on the transmitter.
Table 4. DT sensor wiring to transmitter
DT sensor terminal number
1
2
3
4
5
6
7
8
9
9-wire cable colors
Brown
Red
Orange
Yellow
Green
Blue
Violet
Gray
White
15