Emerson Micro Motion D Série Notice D'installation page 16

STEP 4. Wiring the sensor to the transmitter
Failure to comply with requirements for intrinsic
safety in a hazardous area could result in an
explosion.
• Make sure the hazardous area specified on the sensor
approvals tag is suitable for the environment in which
the sensor is installed. See Figures 1-4.
• For installation in an area that requires intrinsic safety,
refer to Micro Motion UL, CSA, SAA, or ATEX
documentation, shipped with the sensor or available
from the Micro Motion web site.
• For hazardous area installations in Europe, refer to
standard EN 60079-14 if national standards do not
apply.
Failure to seal the sensor junction box housing and
transmitter housing could cause a short circuit,
which would result in measurement error or
flowmeter failure.
• Ensure integrity of gaskets and o-rings.
• Install drip legs in conduit or cable.
• Seal all conduit openings.
WARNING
CAUTION
12