Filling The Reservoir - Medela SoftFeeder Mode D'emploi

3. Slip the reservoir into the collar.
4. Put assembled valve into the reservoir, making sure that
the valve and high rim of the disk are facing the inside of the
reservoir.
5. Place the reservoir assembly over the bottle and screw all
the parts together using the collar. Tighten the collar securely
to ensure a good seal.

Filling The Reservoir

1. Hold the feeder upright and
remove some air from the reser-
voir by squeezing below the
pads.
2. Keep squeezing and tip the
feeder upside down.
3. Release the pads and some
supplement will enter the reser-
voir.
4. Repeat filling steps 1-3 until
the reservoir is almost filled,
approximately up to the bottom
of the pads. As baby is fed, the
reservoir will automatically
refill.
4 medela ®
2ml per pad
11ml below pads
Feeding Baby
1. Hold feeder horizontally, with a slight
angle upwards on the bottom of the bottle.
Positioning is very similar to holding a pencil.
Angle the feeder so the air that remains rises
to the end of the bottle. Angling the bottle in
this manner is essential to the automatic
refill feature of the reservoir.
2. Begin the flow of supplement by
gently squeezing the two pads on either
side of the reservoir. This will pool the
supplement in the feeding tip of the
reservoir.
3. Use the tip of the reservoir to tickle baby's
mouth open. Lay the rim of the reservoir on baby's lower lip.
4. Tip the feeder so that the supplement pooling in the reser-
voir is fed to baby. Or, allow the baby to lap up supplement
with his tongue.
Cleaning & Sanitizing
the Feeder
If there is some supplement left in the feeder, hold it nearly
horizontal over a sink before unscrewing the collar. The disk
should remain in the reservoir, to prevent supplement from
spilling.
medela ® 5