DeFelsko PosiTector SPG Mode D'emploi page 9

from within the USB connect menu to automatically synchroniz e
upon connection to a PC. Additional measurements added to memory
while connected are synchronized only when the USB cable is
disconnected and reconnected, or when the Sync .net Now option
is selected. WiFi connected gages automatically attempt
synchronization upon power-up.
NOTE: PosiSoft Desktop is required when using USB
connections to synchronize measurements with PosiSoft.net.
Bluetooth Smart
When Enabled
running the PosiTector App (pg.6) via auto-pairing Bluetooth
Smart (BLE) wireless technology.
Sync Batches
Select batches to flag them for synchronization to the
PosiTector App. New batches created while Bluetooth Smart
is enabled are automatically selected.
With Bluetooth Smart enabled, select Sync Batches to transfer
batches to the PosiTector App. This is useful when
selected
switching between smart devices, as only readings and batches
that have yet to be synchronized with any smart device are
synchronized automatically.
NOTE:
If Bluetooth Smart is disabled, data from batches
selected in the Sync Batches menu are held in a queue until
communication with the PosiTector App is re-established.
Send Batches
Transfers selected
(useful when switching between devices).
The Send Batches option is visible in the menu when the Gage
is connected to a smart device running the PosiTector App.
Updates
Determine if a software update is available for your Gage.
See www.defelsko.com/update
WARNING:
an update. All stored measurements will be erased from memory.
(Advanced models only,
, allows communication with a smart device
serial numbers 784000 and greater)
batches to the PosiTector App
The Gage will perform a Hard Reset (pg. 4) after
8