Maintenance; Cleaning The Multiflow Bag; Replacing The Multiflow Filter Bag - BWT Soliflow Notice D'installation Et Conseils D'utilisation

16.

MAINTENANCE

16.1

Cleaning the multiflow bag

Inspect the interior of the cyclone regularly and remove any leaves or other debris. This will improve the
filtration flowrate and prolong the service life of the multiflow bag. The frequency of inspections will depend
on the pool environment.
16.2

Replacing the multiflow filter bag

The multiflow bag should be replaced every 4 to 5 weeks on average. The actual replacement frequency
will be determined by the pool volume and the level of pollution.
A drop in the return flow rate and/or turbulence in the Cyclone indicates that the filter bag is clogged.
To facilitate removal of the multiflow bag, empty it following the instructions provided below:
• raise the multifow bag slightly and twist the long hex head key towards the interior of Soliflow
• rest the multifow bag on the long hex head key.
• using the hand pump, remove water from the multiflow bag.
• once the water level has dropped sufficiently, remove the bag and Cyclone.
Replace the bag.
Put the Cyclone and the level regulator splash lip back in position.
Soliflow is ready to go again.
34/40
2021/01 - Indice de révision : I - Code : 26901
Remove the splash lip from
the level regulator.
BWT myPOOL
FILTRATION