Switching On/Off The Led Spots; Indicator Signals - Atag ES9011EVM Instructions De Montage

OPERATION

Switching on/off the LED spots

You can always switch on the spots, even if the hood isn't in standby.
1. Press the lighting key.
The key becomes illuminated for 100% and the lighting will switch on at maximum setting.
2. Dim the lighting by pressing and holding the lighting key.
The lighting strength will change from maximum to minimum and vice versa.
3. Press the lighting key again to switch off the lighting completely.
Attention!
This hood is fitted with LED light! These have to be replaced by an authorized technician.
Do not attempt to replace LED light by yourself.

Indicator signals

Your hood is equipped with indicator signals which indicate when the grease collector has to
be cleaned and when a filter (if installed; depending on the model) needs to be replaced. The
chapter 'Maintenance' describes how this can be done.
Grease collector indicator signal
If the hood is in standby, the grease collector indicator signal is always illuminated 100%.
• The indicator signal is illuminated 100%; this indicates that you can use the hood.
• The indicator signal is illuminated orange; this indicates that the grease collector has to be
cleaned.
▷ Every 3 months the indicator signal becomes illuminated orange. If the cleaned grease
collector is reinstalled, the memory will reset automatically so the indicator signal
becomes illuminated orange again after 3 months.
EN 7