Removing The Grease Filters; Replacing The Carbon Filter - Atag WS90211JM Notice D'utilisation

MAINTENANCE
Grease filters
Carbon filter

Removing the grease filters

Switch off the electricity! Remove the plug from the socket or switch
the electricity off at the mains. Press the handle lock backwards and tilt
the grease filter downwards at the front.

Replacing the carbon filter

The carbon filter must always be used if the cooker hood is not ducted.
Disassembly
Remove the carbon filter by turning the twist locks on the front 90°.
Carefully remove the filter.
Assembly
First hook the carbon filter on the metal tab on the back of the hood
and then secure the front, with the two twist locks, by turning them a
quarter turn.
Note:
• The regenerable activated carbon filter can be washed by hand or
in the dishwasher at a maximum temperature of 65 °C. The washing
cycle must be done without other dishes and without dishwasher
detergent. Do not use any cleaning agents!
• Remove excess water. Be careful to avoid damaging the filter.
Let the filter dry in the oven for at least 1 hour at a maximum
temperature of 80 °C. After a maximum of 3 years (or when the filter
is damaged), the filter will need to be replaced.
It is important that the grease filters and the regenerable activated
carbon filter are properly dried before installation.
EN 9