Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
fan
(continued)
switching off the fan
Press the
The extractor hood switches off and the light of the symbol
in the button goes out.
automatic continued operation
Choose the fan setting desired and press the
The symbol in the button lights up.
After approximately 15 minutes, the extractor hood switches
back automatically and finally switches off. If the lighting
was switched on during the automatic continued running, it
will remain switched on
GB 4
button.
button.
faults
Please check the following points which may solve the problem, before calling the service
department.
If the connection cable is damaged, it should be replaced by the service department of the
manufacturer or similarly qualified persons in order to prevent dangerous situations from arising.
NB: Disconnect the appliance from the mains before starting any repairs, preferably by removing
the plug from the socket or by setting the isolation switch to zero.
fault
cause
Lighting does not work.
Lamp defective.
NB:
Only use the same type of lamp
with the wattage stated.
Extractor hood makes a lot of
Discharge duct too long or has
noise.
too many bends.
Motor defective.
No extraction.
Motor or controls defective.
Connection lead defective.
solution
Turn the light bulb a quarter
turn and remove it from the
fitting.
Replace it with a new 50 W
halogen lamp.
Change the discharge duct
(see installation instructions).
Phone the Service department.
Phone the Service department.
Phone the Service department.
GB 5
Publicité
Table des Matières
