Installing The Appliance - Napoleon CLEARION Serie Instructions D'installation Et D'opération

installation
EN
2.6

installing the appliance

Frame the appliance along with the electrical connections.
A.
Remove the front trims on both front side and back side. Refer to "front trim installation / removal" section.
B.
Remove the front glasses on both front side and back side. Refer to "front glass installation / removal"
C.
section.
To determine the installation location of the mounting bracket, ensure to line up the edge of the mounting
D.
bracket 1/4" (6.4mm) from the center of the wall sides and 6 1/8" (156mm) from the bottom of the wall
sides (FIG. 1 & 2).
Mark the holes for the mounting bracket. Ensure the marked holes are on opposite sides, as the brackets
E.
cannot be mounted on the same side (FIG. 3).
6 1/8" (156mm)
Drill marked holes.
F.
Secure the mounting brackets onto the drilled holes with supplied fasteners (#1 x 4).
G.
Insert the appliance to the frame and secure the appliance to the holes on the bracket using supplied
H.
fasteners (#2 x 4) using the slots from the appliance (FIG. 4).
Install media. Refer to "media installation" section.
I.
Reinstall front trim and glass. Refer to "front trim installation / removal" and "front glass installation /
J.
removal" sections.
note:
It is recommended to have the walls of the appliance enclosure be finished (i.e. drywall) to avoid exposed
insulation or vapour barrier coming in contact with the appliance. This will ensure clearance to combustibles is
maintained.
The mounting bracket must be screwed into the wall studs with at least 2 screws. If the remaining screws
cannot be screwed into a stud, ensure that plastic anchors are used to affix the bracket to the wall and that the
bracket is adequately secured.
Wall anchors are not required when screwing into the wall stud.
It is recommended to use a magnetic screwdriver bit during installation to prevent the screws from falling into the
appliance.
12
W415-1767 / C / 01.29.18
FIG. 1
FIG. 3
FIG. 2
1/4"
(6.4mm)
6 1/8"
(156mm)
FIG. 4
Center of the stud
#1 x 4
#2 x 4