Installing The Appliance - Napoleon Allure Serie Manuel D'installation Et D'utilisation

2.4

installing the appliance

Due to the many different materials used on different walls, it is highly
recommended to consult your local builder before installing this
appliance on the wall.
A.
Select a location that is not prone to moisture and is located at least
36" (91.4cm) away from combustible materials such as curtain drapes,
furniture, bedding, paper, etc.
B.
Have 2 people hold the appliance against the wall to determine the fi nal
location.
C.
Place appliance face down on a soft, non abrasive surface. Remove the
bracket from the back of the appliance by removing the screws (Fig. 1
and 2).
D.
Mark out location, then mount the bracket(s) onto the wall using the supplied screws. This bracket MUST
have the hooks facing upward and be level.
note:
It is strongly recommended that the mounting bracket be screwed into the wall studs where possible. If the wall
studs cannot be used, ensure that the supplied plastic anchors are used to affi x the bracket to the wall and the
bracket is adequately secured.
E.
With the wall mounting bracket
installed, have 2 people lift the
appliance up and insert the 2
hooks on the bracket into the 2
slots on the back of the appliance.
F.
Check the appliance for stability
ensuring that the bracket will not
pull free from the wall.
Fig. 2
HOOK
BRACKET
Fig. 1
NEFL32/42/50FH-EU Bracket Illustrated
NEFL60/72/100FH-EU Bracket Illustrated
installation
GLASS FRONT
SIDE VIEW
FLOOR
SCREWS
W415-1699 / E / 06.01.20
EN
BODY
21 5/8"
55cm
HOOK
11