Installing The Appliance; Wall Mount Installation - Napoleon NEFL60B-1 Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

installation
EN
3.2

installing the appliance

3.2.1 wall mount installation

note:
The wall bracket is fixed on the back of the appliance.
Due to the many different materials used on different walls, it is highly
recommended that you consult your local builder before you
install this appliance on the wall.
Select a location that is not prone to moisture and is located at least 3 feet (1m) away from combustible
A.
materials such as curtain, drapes, furniture, bedding, paper, etc.
Remove the wall mounting bracket from the appliance by unscrewing the 2 screws holding the wall
B.
mounting bracket to the appliance (Fig. 3-1).
Have two people hold the appliance against the wall to determine the final location.
C.
note:
It is strongly recommended that the mounting bracket be screwed into the wall studs where possible. If the wall
studs cannot be used, ensure that the supplied plastic anchors are used to affix the bracket to the wall and the
bracket is adequately secured.
Mark out location, then mount the bracket onto the wall using screws (supplied) (Fig. 3-2). This bracket
D.
MUST have the hooks facing upward and be level.
With the wall mounting bracket installed, have two people lift the appliance up and align the slots on the
E.
back of the appliance with the hooks on the wall bracket.
Secure the appliance to the wall bracket using the 2 screws previously removed in Step B.
F.
X2
Fig. 3-1
10
W415-2103 / B / 08.24.20
Screws
Mounting Bracket
SLOTS
REAR VIEW
A
B
X9
X9
D
Fig. 3-2
C
E

Publicité

Chapitres

Table des Matières
loading

Table des Matières