Media Installation; 4.3.1 Log Set And Topaz Glass Installation; Acrylic Crystal Media Installation - Napoleon CLEARION Serie Instructions D'installation Et D'opération

Masquer les pouces Voir aussi pour CLEARION Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

finishing
EN
4.3

media installation

There are 2 media options for this appliance: log set and acrylic crystals. The log set assembly comes pre-installed
with the appliance and has to be finished with topaz glass. Refer to "log set and topaz glass installation" section. If
desired, this can be switched out with acrylic crystals. Refer to "acrylic crystal media installation" section.

4.3.1 log set and topaz glass installation

Install the log set and topaz glass after framing the appliance and before installing the front glass.
If log set assembly is installed:
Carefully place the topaz glass between the log set assembly (front and back side).
A.
If acrylic crystal media is installed:
Ensure to remove all acrylic crystals from the ember bed.
A.
Remove fasteners from the media tray (FIG. 1).
B.
Remove media tray (FIG. 2).
C.
Install log set assembly (FIG. 3).
D.
Carefully place the topaz glass between the log set assembly.
E.
Repeat steps on the opposite side.
F.
note:
Do NOT cover triangular covers on the back side of the unit. Blocking the triangular covers with media will alter
the flame appearance.
FIG. 1

4.3.2 acrylic crystal media installation

Install the acrylic crystal media after framing the appliance and before installing the front glass.
Remove the fasteners from the log set assembly.
A.
Remove log set assembly.
B.
Install media tray using previously removed fasteners from the
C.
log set assembly and secure with additional supplied fasteners (4
screws for front media tray and 1 screw for back media tray).
Carefully place acrylic crystals into the media tray, creating an even
D.
layer from side to side.
Repeat steps on the opposite side.
E.
note:
Ensure to vacuum up any topaz glass or acrylic crystals outside the media tray area before operation.
Do NOT cover triangular covers on the back side of the unit. Blocking the triangular covers with media will alter
the flame appearance.
18
W415-1767 / C / 01.29.18
FIG. 3
FIG. 2
#12 x 5
FIG. 3
FIG. 3
FIG. 3

Publicité

Chapitres

Table des Matières
loading

Table des Matières