Installing The Appliance; Wall Mount Installation - Napoleon NEFL50B-1 Manuel D'installation Et D'opération

installation
EN
3.2

installing the appliance

3.2.1 wall mount installation

note:
The wall bracket is fixed on the back of the appliance.
Due to the many different materials used on different walls, it is highly
recommended that you consult your local builder before you
install this appliance on the wall.
Select a location that is not prone to moisture and is located at least 3 feet (1m) away from combustible
A.
materials such as curtain, drapes, furniture, bedding, paper, etc.
Remove the wall mounting bracket from the appliance by unscrewing the 2 screws from the wall
B.
mounting bracket (Fig. 1).
Have two people hold the appliance against the wall to determine the final location.
C.
note:
It is strongly recommended that the mounting bracket be screwed into the wall studs where possible. If the wall
studs cannot be used, ensure that the supplied plastic anchors are used to affix the bracket to the wall and the
bracket is adequately secured.
Mark out location, then mount the bracket onto the wall using the 5 supplied screws (A x 5). This bracket
D.
MUST have the slots facing upward and be level.
With the wall mounting bracket installed, have two people lift the appliance up and align the hooks on the
E.
back of the appliance with the slots on the wall bracket (Fig. 2).
Secure the appliance to the wall bracket using the 2 screws previously removed in Step B (Fig. 1).
F.
X2
10
W415-1843 / A / 09.11.18
Fig. 1
SLOTS
A
REAR VIEW
X5
D
GLASS
SIDE VIEW
BRACKET
SCREWS
SLOTS
REAR VIEW
B
C
X5
E
Fig. 2