Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
general information
EN
1.3
general instructions
•
Prior to plugging your appliance into an electrical outlet, verify that the house circuit breakers for the outlet
are on.
•
The appliance may emit a slight, harmless odour when fi rst used. This odour is normal and it is caused by
the initial heating of internal appliance elements and will not occur again.
•
If your appliance does not emit heat, consult the "operation" section of this manual for further information.
•
Use with a CSA or UL certifi ed surge protector.
•
Do not route the power cord directly underneath the appliance.
This electric applaince meets the construction and safety standards of H.U.D. for application in manufactured
homes when installed according to these instructions.
As with most electronic devices, your new electric fireplace has been designed to operate at
temperatures between 5°C (41°F) and 35° C (95°F). During the colder winter months, allow the
fireplace to reach room temperature before turning it on.
1.4
unpacking and testing appliance
Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the appliance
operates properly by plugging the power supply cord into a conveniently located 120 volt, 15 amp grounded
outlet.
The appliance comes with medium density fiberboard (MDF board) installed on the sides. Remove fasteners on
each side (FIG. 1), and then discard both MDF boards.
Use 4 supplied fasteners on each side to cover MDF board fastener holes (FIG. 2).
#2 x 8
6
W415-1767 / C / 01.29.18
4.6
Caution Label
W385-2236
FIG. 1
FIG. 2
Publicité
Chapitres
Table des Matières
