Installing The Appliance - Napoleon EFL42 Instructions D'installation Et D'opération

3.3

INSTALLING THE APPLIANCE

Due to the many different materials used on different walls, it is highly recommended that you consult your
local builder before you install this appliance on the wall.
A. Select a location that is not prone to moisture and is located at least
36" (914mm) away from combustible materials such as curtain
drapes, furniture, bedding, paper, etc.
B. Have two people hold the appliance against the wall to determine the
fi nal location.
C. Remove the bracket from the back of the unit by removing the two
screws, refer to Figure 1.
D. NOTE: It is strongly recommended that the mounting bracket
be screwed into the wall studs where possible. If the wall studs
cannot be used, ensure that
the supplied plastic anchors
are used to affi x the bracket
to the wall and the bracket
is adequately secured. Mark
out location, then mount the
bracket onto the wall using the
8 supplied screws. This bracket
MUST have the hooks facing upward and be level.
E. With the wall mounting bracket installed have two people lift the appliance up and insert the two hooks
on the bracket into the two slots on the back of the appliance.
F. Check the appliance for stability ensuring that the bracket will not pull free from the wall.
FIG. 1
HOOK
BRACKET
GLASS FRONT
SIDE VIEW
FLOOR
SCREWS
W415-1134 / B / 07.13.15
9
BODY
EN
18"
457mm
HOOK