Installing The Appliance - Napoleon EFL50H Instructions D'installation Et D'opération

8
3.3

INSTALLING THE APPLIANCE

Due to the many different materials used on different walls, it is highly recommended that you consult your
local builder before you install this appliance on the wall.
EN
A. Select a location that is not prone to moisture and is located at least
36" (914mm) away from combustible materials such as curtain drapes,
furniture, bedding, paper, etc.
B. Have two people hold the appliance against the wall to determine the
fi nal location.
C. Remove the bracket from the back of the unit by removing the two
screws, refer to Figure 1.
D. Mark out location, then mount the bracket onto the wall using the 8
supplied screws. This bracket MUST have the hooks facing upward
and be level. NOTE: It is strongly recommended that the mounting
bracket be screwed into the wall studs where possible. If the wall studs cannot be used, ensure
that the supplied plastic
anchors are used to affi x
the bracket to the wall and
the bracket is adequately
secured.
E. With the wall mounting
bracket installed have two
people lift the appliance up and insert the two hooks on the bracket into the two slots on the back of
the appliance.
F. Check the appliance for stability ensuring that the bracket will not pull free from the wall.
FIG. 1
W415-1223 / A / 01.11.14
HOOK
BRACKET
GLASS FRONT
FLOOR
WALL MOUNT
BRACKET
SCREWS
BODY
17 1/4"
438mm
SIDE VIEW
HOOK