Installing The Appliance - Napoleon CLEARion Serie Manuel D'installation Et D'opération

installation
EN
2.6

installing the appliance

note:
It is recommended to have the walls of the appliance enclosure be finished (i.e. drywall) to avoid exposed
insulation or vapour barrier coming in contact with the appliance. This will ensure clearance to combustibles is
maintained.
Wall anchors are not required when screwing into the wall stud.
It is recommended to use a magnetic screwdriver bit during installation to prevent the screws from falling into the
appliance.
Frame the appliance along with the electrical connections.
A.
Remove the trims on both front side and back side (see "front trim installation / removal" section).
B.
Remove the glass on both front side and back side (see "front glass installation / removal" section).
C.
Install mounting bracket by aligning the edge 1/4" (6.4mm) from the center of the wall sides and 6 1/8"
D.
(156mm) from the bottom of the wall sides (Fig. 1). Use the mounting bracket installation template on the
next page.
6 1/8" (156mm)
Mark the holes for the mounting bracket. Ensure the marked holes are on opposite sides, as the brackets
E.
cannot be mounted on the same side (Fig. 2).
Drill marked holes and secure the mounting brackets with fasteners (supplied).
F.
Secure appliance to the brackets using 4 fasteners (supplied) and the slots from the appliance (Fig. 3).
G.
Install media (see "media installation" section).
H.
Reinstall front trim and glass (see "front trim installation / removal" and "front glass installation / removal"
I.
sections).
12
W415-1767 / F / 07.20.18
All manuals and user guides at all-guides.com
Fig. 2
Center
1/4" of stud
(6.4mm)
6 1/8"
(156mm)
Fig. 1
#1 x 4
#2 x 4
Fig. 3