Installing The Appliance Onto The Wall - Napoleon ALLURAVISION Serie Manuel D'installation Et D'utilisation

4.3

installing the appliance onto the wall

Due to the many different materials used on different walls, it is highly recommended that you consult your local
builder before you install this appliance on the wall.
1. Select a location that is not prone to moisture and is located at least 36" (91.4cm) away from combustible
materials such as curtain drapes, furniture, bedding, paper, etc.
2. Remove the front glass, refer to "front glass removal" section.
3. Install side cover. Refer to "Trim and Side Cover" section.
4. Have two people hold the appliance against the wall to determine the final location.
5. Place appliance face down on a soft, non-abrasive surface. Remove the bracket from the back of the
appliance by removing the screws, refer to Figure 1.
6. Mark out location, then mount the bracket(s) onto the wall using the supplied screws. This bracket must have
the hooks facing upward and be level.
note:
It is strongly recommended that the mounting bracket be screwed into the wall studs, where possible. If the
wall studs cannot be used, ensure that the plastic anchors (supplied) are used to affix the bracket to the wall
and the bracket is adequately secured.
7. With the wall mounting bracket installed, have two people lift the appliance up and insert the two hooks on
the bracket into the two slots on the back of appliance.
8. Check the appliance for stability ensuring that the bracket will not pull free from the wall.
9. Place the drift wood logs and topaz glass chips or crystals along the media tray, refer to " drift wood logs and
topaz glass chips installation" section.
10. Install front glass. Refer to "front glass install / removal" section
note:
For NEFL32/42/50CHS/D models, there will be only 1 wall bracket attached to the back of the appliance.
HOOK
Wall Brackets
SCREWS
installation
HOOK
FIG. 1
W415-2212 / 08.22.17
EN
11