Setting The Time Format; Standby Clock; Auto Standby - TechniSat DIGITRADIO 370 CD IR Mode D'emploi

[Update from NET] (Update via Internet radio only)
[No Update] (Time/date must be entered manually, see Section 16.4.1).
> Press the ENTER button to save the setting.
If you have selected [Update from NET], you must also configure the time
zone and the summer/winter time setting. This is done under [System
Settings] > [Time and Date] > [Set Time Zone] and [System Settings]
>[Time and Date] > [Summer time?].

16.4.3 Setting the time format

Under Time format you can activate the 12 or 24 hour format.
Press the MENU button and use the / buttons to select the [System
>
Settings] > [Time and Date] > [Time Format] item, then press ENTER.
Use / to choose one of the following options:
>
[24 hours]
[12 hours]
> Press the ENTER button to save.

16.4.4 Standby clock

Here you can configure the time display in standby mode. You can choose between
the analogue display or the digital display.
Press the MENU button and use the / buttons to select the [System
>
Settings] > [Time and Date] > [Standby Clock] item, then press ENTER.
Use / to choose one of the options.
>
> Press the ENTER button to save.

16.5 Auto Standby

The DIGITRADIO 370/371 CD IR can automatically switch to standby mode after not
being used for a specified time.
Press the MENU button and use the / buttons to select the [System
>
Settings] > [Auto Standby] item, then press ENTER.
Use / to select a time after which the device should switch to standby.
>
> Press the ENTER button to save.
In Bluetooth, CD, AUX and USB modes, the device will automatically switch to
standby mode after approx. 15 minutes if no sound is played.
82