Manual Setting; Volume Adjustment (Drc); Deleting Inactive Stations - TechniSat DIGITRADIO 370 CD IR Mode D'emploi

Stations with a signal intensity below the required minimum signal intensity
are not transmitting a strong enough signal. Align the telescopic antenna as
described in section 4.3.1 if required.

7.2.7 Manual setting

This menu item is used to check the reception channels and can be used to align the
antenna. Furthermore, stations can be added manually.
Briefly press the MENU button and use the / buttons to select the >[Set
>
Manually] item. Then press the ENTER button.
Use the / and ENTER buttons to select a channel (5A to 13F). The signal
>
intensity will now be shown on the display. If a DAB+ station is being received
on a channel, the station ensemble name is displayed. The antenna can now
be aligned to the maximum signal intensity.
Stations with a signal intensity below the required minimum signal intensity
are not transmitting a strong enough signal. Align the telescopic antenna as
described in Section 4.3.1 if required.
If there are stations on the set frequency or channel that have not yet been
stored in the station list, they will now also be saved.

7.2.8 Volume adjustment (DRC)

The DRC menu item is used to set the compression rate, which compensates for
dynamic fluctuations and the associated volume variations.
Press the MENU button and use the / buttons to select the [Volume
>
Adjustment] item.
Press the ENTER button.
>
DRC high -
DRC low -
DRC off -
> Confirm the setting with ENTER.

7.2.9 Deleting inactive stations

This menu item is for removing old stations and those no longer being received from
the station list.
Press the MENU button and use the / buttons to select the [Remove
>
Inactive Stations] item.
> Press the ENTER button.
This is followed by the [Delete] prompt asking if the inactive stations are to be
deleted.
Use / to select the [Yes] item and confirm by pressing the ENTER button.
>
High compression
Low compression
Compression switched off.
DE
EN
FR
NL
65